# content
R406       *Fill BUMPER corners. Corner joints between BUMPERS must be filled with uncompressed padding material extending at least 2 ¼ in. (~58 mm) from the corner with no gaps or voids. Examples of implementation are shown in Figure 8‑7.

Figure 8‑7 Uncompressed corner padding

Examples that do not meet the requirements of R406:

A.      Foam cylinders or sheets bent around a sharp corner (less than 135°) are considered compressed.

B.      Separate bumper segments meeting at a miter in the corner are not considered to “fill” the corner due to the cloth covering.

# contentMap.en
R406       *Fill BUMPER corners. Corner joints between BUMPERS must be filled with uncompressed padding material extending at least 2 ¼ in. (~58 mm) from the corner with no gaps or voids. Examples of implementation are shown in Figure 8‑7.

Figure 8‑7 Uncompressed corner padding

Examples that do not meet the requirements of R406:

A.      Foam cylinders or sheets bent around a sharp corner (less than 135°) are considered compressed.

B.      Separate bumper segments meeting at a miter in the corner are not considered to “fill” the corner due to the cloth covering.