Rule R616

R616 *Power radio as specified – Part 1. The wireless bridge (radio) power must be supplied by either:

A. the 12V 2A output of a CTR Electronics Voltage Regulator Module (VRM) (P/N am-2857, 217-4245), as shown in Figure 8‑12, and must be the only load connected to those terminals or

Figure 8‑12 Radio power source from a VRM

P1644#yIS1

B. using an Ethernet cable between a REV Radio Power Module (RPM) (P/N REV-11-1856) and the “RIO” Ethernet port on the wireless bridge, or

C. directly from the PDP or PDH ports described in R617.

Note that this prohibits using any other active POE injector device to power the radio but does not prohibit using any PASSIVE CONDUCTORS to inject the VRM or direct PDP/PDH power into an Ethernet cable plugged into the radio port labeled “RIO.”