R716       *Don’t alter the CAN bus. No device that interferes with, alters, or blocks communications among the roboRIO and the PCMs/PHs, and/or CAN motor controllers on the bus will be permitted.

R714       *Control CAN motor controllers from the roboRIO. Each CAN motor controller must be controlled with enable/disable inputs sourced from the roboRIO and passed via either a PWM (wired per R713) or CAN bus (either directly or daisy-chained via another CAN bus device) signal, but both shall not be wired simultaneously on the same device.

R715       *Control PCM, PH, and Servo Hub from roboRIO. Each Pneumatic Control Module (PCM), Pneumatic Hub (PH), and Servo Hub must be controlled with signal inputs sourced from the roboRIO and passed via a CAN bus connection from the built-in CAN on the roboRIO (either directly or daisy-chained via another CAN bus device).

R701       *Control the ROBOT with a roboRIO. ROBOTS must be controlled via 1 programmable NI roboRIO or roboRIO 2.0 (P/N am3000 or am3000a, both versions referred to throughout this manual as “roboRIO”), with image version 2026_v1.2 or later.