Rule R808

R808 *Working air pressure limit. Working air pressure (air pressure used to actuate devices) on the Robot must be no greater than 60 psi (~413 kPa) and must be provided through a single primary adjustable, relieving, pressure regulator.

Examples of acceptable valves include Norgren regulator P/N R07-100-RNEA and Monnier P/N 101-3002-1.

Similar Rules

Rule R807

R807 *Air storage pressure limit. Stored air pressure on the Robot must be no greater than 120 psi (~827 kPa). No stored air pressure intended for the Robot may be located off-board the Robot.

Rule R802

R802 *No custom pneumatics and meet minimum pressure ratings. All pneumatic items must be COTS pneumatic devices and either:

Rule R809

R809 *Limited devices at high pressure. Only the compressor, relief valve, pressure switch, pressure vent plug, pressure gauge, storage tanks, tubing, pressure transducers, filters, and connecting fittings may be in the high-pressure pneumatic circuit upstream from the regulator.

Rule R806

R806 *Compressed air from robot compressor only. Throughout an event, compressed air on the Robot must be provided by its 1 onboard compressor only. Compressor specifications must not exceed nominal 1.1 cfm (~519 cm3/s) flow rate @ 12VDC at any pressure.