FRCTools

R808       *Working air pressure limit. Working air pressure (air pressure used to actuate devices) on the ROBOT must be no greater than 60.0psi (413.7kPa, 4.137Bar) and must be provided through a single primary adjustable, relieving, pressure regulator. Additional regulators may be located downstream of the single primary regulator.

Examples of acceptable valves include Norgren regulator P/N R07-100-RNEA and Monnier P/N 101-3002-1.

Similar Rules

Rule R807
R807       *Air storage pressure limit. Stored air pressure on the ROBOT must be no greater than 120.0psi (~827 kPa, 8.2 Bar). No stored air pressure intended for the ROBOT may be located off-board the ROBOT.
Rule R802
R802       *No custom pneumatics and meet minimum pressure ratings. All pneumatic items must be COTS pneumatic devices and either:
Rule R809
R809       *Limited devices at high pressure. Only the compressor, relief valve, pressure switch, pressure vent plug, pressure gauge, storage tanks, tubing, pressure transducers, filters, and connecting fittings may be in the high-pressure pneumatic circuit upstream from the regulator.
Rule R806
R806       *Compressed air from ROBOT compressor only. Throughout an event, compressed air on the ROBOT must be provided by its 1 onboard compressor only. Compressor specifications must not exceed nominal 1.1cfm (519.1cm3/s) flow rate @ 12VDC at any pressure.