FRCTools

R707       *Configure devices for your team number. The ROBOT CONTROLLER, DRIVER STATION, and any spares used must be configured/named to correspond to the correct team number as follows:

A.      ROBOT CONTROLLER should be named <team number>-RC (e.g., 12345-RC),

B.      DRIVER STATION should be named <team number>-DS (e.g., 12345-DS), and

C.      If a spare ROBOT CONTROLLER or DRIVER STATION is configured, a letter designator may be added <team number>-<letter>-RC/DS (e.g., 12345-A-DS, 12345-B-DS)

See the DRIVER STATION Instructions and ROBOT CONTROLLER Instructions for a detailed procedure for updating DRIVER STATION and ROBOT CONTROLLER “names.”

Similar Rules

Rule R718
R718       *Configure Android devices appropriately. ROBOT CONTROLLER and DRIVER STATION Android devices (smartphones, REV Control Hub, REV Driver Hub) must additionally be configured in the following ways:
Rule R901
R901       *Use only a specified DRIVER STATION device. The OPERATOR CONSOLE may only have one approved android-based DRIVER STATION device connected and powered on. The OPERATOR CONSOLE must have at least one of the following:
Rule R701
R701       *Control the ROBOT with a single ROBOT CONTROLLER. ROBOTS must be controlled via 1 programmable ROBOT CONTROLLER. The ROBOT CONTROLLER is the only source of control for the ROBOT actuators and must be comprised of: 
Rule R708
R708       *Do not interfere with the ROBOT networks. During a MATCH, all communications signals must originate from only the ROBOT CONTROLLER device or the DRIVER STATION device using the ROBOT CONTROLLER Wi-Fi network. No other devices may attempt to connect to, interfere with, or alter the ROBOT CONTROLLER Wi-Fi network.