FRCTools

R619       *Only use specified circuit breakers in a PD. The only circuit breakers permitted for use in the PD are:

A.      Snap Action VB3-A Series or AT2-A, terminal style F57, 40A rating or lower,

B.      Snap Action MX5-A or MX5-L Series, 40A rating or lower,

C.      REV Robotics ATO auto-resetting breakers 40A rating or lower,

D.      CTR Electronics ATO auto-resetting breakers 40A rating or lower, and

E.      Any ATM circuit breaker with value less than or equal to the fuses permitted per R620.

Similar Rules

Rule R621
R621       *Protect circuits with appropriate circuit breakers. Each branch circuit must be protected by 1 and only 1 circuit breaker or fuse on the PD per Table 8‑3. No other electrical load can be connected to the breaker or fuse supplying this circuit with the exception of devices downstream of a permitted motor power adapter board placed between the PD and a motor controller (WCP-1380, RF-4003, RF-4004, RF-4005).
Rule R620
R620       *Only use specified fuses in PD. The only fuses permitted for use in the PD are automotive blade fuses with the following values:
Rule R610
R610       *1 breaker/fuse per circuit. All circuits, with the exceptions of those listed in R615 and R617, must connect to, and have power sourced solely by, a single protected connector pair of the PD. Circuits must not connect to the main power input of the PD.
Rule R618
R618       *Use PD terminals as designed. Only 1 wire shall be connected to each terminal on the PD.